Hitachi UX2 - Page 66

Chapter 4. Basic Operation
4-12
Turn ON the power by pressing the main power switch.
The power is turned on, and the [HOME] screen appears.
(If the [Select login user] screen appears, see the next page.)
If the power is not turned on, it may have been shut down with the STOP switch last time. Press the ON
switch for about two seconds to turn on the power.
* To turn on the power again, ensure that the operating status indicator lamps are off.
2
Operating
status indicator
Operating status indicator
lamps
Displays "Ready",
"Fault" and "Warning".
Main power switch
Turns the unit ON and OFF.
ON/STOP switch
Starts or stops the unit with the main power on.
If the unit was stopped last time only by the STOP
switch without using the main power switch, the main
power switch does not have to be pressed.