- 7 -
HLP-C
+
Inverters
Caution
● Do not touch the heat sink, braking resistor, or other heat
elements. These can become very hot.
● Be sure that the motor and machine is within the applicable
speed ranges before starting operation because the inverter
is quite easy to run from lower speed to higher speed.
● Do not check the signals on circuit boards while the inverter
is running to avoid danger.
● Be careful when changing the inverter settings. The inverter
has been adjusted and set before ex-work. Do not adjust it
wantonly. Please make proper adjustments according to the
required functions.
● Do consider the vibration, noise and the speed limit of the
motor bearings and the mechanical devices when the inverter
is running at or above the frequency of 50Hz.
To Next Page
Loading...
