Honeywell 2MLF-AV8A - Write Operation Parameters Settings Area (PUT, PUTP Command)

6. Programming
6.1. Read/Write of operation parameter settings area
108 Analog Input Module 2MLF-AV8A, AC8A User's Guide R200
Honeywell September 2010
Write operation parameters settings area (PUT, PUTP command)
Type Description Area available
n1
Slot number where the special module is installed
Integer
n2
Start address of special module’s internal memory to write
data.
Integer
S Device’s start address or integer with saved data to write.
M,P,K,L,T,C,D,#
D,integer
n3 Number of word data to write Integer
< Difference between PUT command and PUTP command >
PUT: Always executed with execution condition On ( )
PUTP: Executed with execution condition of operation start ( )
Example