Honeywell 2MLF-AV8A User Manual

7. Troubleshooting
7.2. Troubleshooting
R200 Analog Input Module 2MLF-AV8A, AC8A User's Guide 131
September 2010 Honeywell
7.2 Troubleshooting
RUN LED blinks
Error Code
(Dec)
Error Details Action
40#
Module Offset/Gain error
Turn the power ON/OFF. If the error recurs, it is
likely that the module is defective. Contact the
nearest Honeywell agency or branch office.
41#
42#
43#
50#
Filter constant setting
range exceeded
Change filter constant setting value within 1 ~ 99.
60#
Time average setting
range exceeded
Change time average setting value within 4 ~
16000.
70#
Frequency average
setting range exceeded
Change frequency average setting value within 2
~ 64000.
80#
Analog input range error
(Only 2MLF-AC8A)
Refer to Address 1- input Voltage/Current section
and then change the analog input range.
RUN LED blinks
RUN LED blinks every 0.2 sec.
Switch the module power OFF and then turn it ON. If the
error recurs, it is likely that the module defective. Contact the
nearest Honeywell office or authorized service engineer.
RUN LED blinks every 1 sec.
Run parameters setting error. Check the error code in the
table below.
Yes
No
Yes

Honeywell 2MLF-AV8A Specifications

General

Brand	Honeywell
Model	2MLF-AV8A
Category	I/O Systems
Language	English