7. Troubleshooting
7.1. Error codes
130 Analog Input Module 2MLF-AV8A, AC8A User's Guide R200
Honeywell September 2010
ATTENTION
1. # of the error code stands for the channel with error found.
2. If two or more errors occur, the module saves only the first error code.
3. When the error is found and corrected, use the ‘flag to request error
clear’. For more information, refer Error Clear request Flag (UXY.11.0, X:
Base No., Y: Slot No); or restart the unit. This stops the blinking LED and
has the unit ready to detect the next error code.
To Next Page
Loading...
Need help?
General
