Honeywell Esser 8010 User Manual

Extinguishing Control Computer 8010 – 19-Inch
FB 798955.GB0 / 09.07 59
7.5.3 Relay outputs, 10 and 11
Free programmable, dry contact relays for low voltages.
The two relays 10 and 11 can be configured for the emergency operation via the appropriate jumpers. During
emergency operation, the corresponding relay mode is permanently assigned to the two relays. In a CPU-
failure-mode of the system these relays are activated.
Wiring of relay 9, 10 and 11 (Relay-terminal card type Phoenix)
Terminal card
T2A T2A T2A
353637
3839
404142434445
NC
NO
C
NC
NO
C
NC
NO
C
Relay 11
Relay 10 Relay 9
Power supply and relay board
F2
F3
F4
Emergency
operation
REL9
REL10
REL11
Fig. 43: Schematic wiring of the three dry contact relays 9, 10 and 11
Relay 9
Without CPU-failure-mode capability
Relay 10
Relays for low voltages without emergency operation mode or
selectable via jumper setting for >Emergency operation fire<
(refer to section “Emergency operation“)
Relay 11
Relays for low voltages without emergency operation mode or
selectable via jumper setting for >Emergency operation trouble<
(refer to section “Emergency operation“)
Changeover contacts,
contact rating
max. 30 V DC / 2 A

Honeywell Esser 8010 Specifications

General

Brand	Honeywell
Model	Esser 8010
Category	Desktop
Language	English