Honeywell IntelliDoX User Manual

INTELLIDOX DOCKING MODULE USER MANUAL || DETECTOR OPERATIONS
HONEYWELL PAGE 56 OF 119
Special Considerations for IntelliDoX BW Icon (DX-CP)
Note: The external filter on BW Icon is supported while docked into IDX BW Icon
(DX-CP) and does not need to be removed. If the detector fails calibration, check for
and replace a dirty filter, then calibrate again.

Honeywell IntelliDoX Specifications

General

Data Logging	Yes
Calibration	Automatic
Bump Testing	Automatic
Instrument Management	Yes
Input Voltage	100-240 VAC, 50/60 Hz
Enclosure Rating	IP20
Connectivity	Ethernet, USB
Operating Temperature	0°C to 40°C (32°F to 104°F)
Humidity Range	10% to 90% (non-condensing)
Communication Protocol	Modbus TCP/IP