What to do if Honeywell MCT404 Cell Phone offline download failed with 'Send command failed or invalid' message?
If the Honeywell Cell Phone shows a 'Send command failed or invalid' message during offline download, it could be due to a send command failure or a potential issue with communication. In such cases, retry the offline download for the failed items.
Why is my Honeywell MCT404 unable to launch or open MC Toolkit application?
The Honeywell Cell Phone might be unable to launch the MC Toolkit application because: * MC Toolkit is installed in the device memory instead of the SD card. Re-installing MC Toolkit in the SD card may solve this. * One or more dependent files are corrupt. Re-installing MC Toolkit in the SD card may also address this issue.
Why is my Honeywell Cell Phone unable to launch or open FDC application?
The Honeywell Cell Phone might be unable to launch the FDC application due to several reasons: * .NET CF 3.5 may not be installed. Installing .NET CF 3.5. * FDC may be installed in the device memory instead of the SD card. Try re-installing FDC in the SD card. * One or more dependent files might be corrupt. Try re-installing FDC in the SD card.
General| Form Factor | Bar |
|---|---|
| Type | Feature Phone |
| Display | 2.4-inch TFT |
| Resolution | 240 x 320 pixels |
| Expandable Storage | MicroSD up to 32GB |
| Operating System | Proprietary |
| Battery | Removable Li-Ion 1000 mAh |
| Camera | VGA |
| Dimensions | 130 x 50 x 16 mm |
Instructions for installing the MC Toolkit software.
Provides general and specific safety regulations for using MCT404.
Guides on connecting the MC Toolkit to a field device.
Procedures for adding, deleting, and validating DD files.
Steps for modifying device variable values.
How to send edited variable values to the device.
Steps for executing device-specific methods or functions.
Explains how to configure DE devices online.
Procedures for online configuration of DE transmitters.
Steps for input calibration (Zero, LRV, URV) and resetting corrects.
Verifies integrity of electrical components in the output current loop.
Calibrates analog output current for DE transmitters.
Manually sets PV input to 0% (LRV) and 100% (URV).
Lists common startup problems for MCT404.
Troubleshooting for FDC application startup, DD library, and device identification.
Troubleshooting for MC Toolkit login, help, and error messages.
Lists common MC Toolkit error messages and their solutions.
Lists error messages related to DE devices and their resolutions.
Lists error messages related to offline configuration.
To Next Page
