Honeywell SC Series - 2.4 Use the SETUP Menus to Enter Transducer Information; 2.5 Calibrate the Transducers to Their Channels

Honeywell Sensing and Control 5
SC 2000, SC2001, SC3004
Rev. G, 008-0608-00
2.4 Use the SETUP Menus to Enter
Transducer Information
You can skip this step if:
• YouareusingatransducerequippedwithSignature Calibra-
tion, or
• Thetransducerandinstrumentwerepurchasedtogetherand
set up by Honeywell.
Otherwise, you must enter information about your transducer into
the SETUP menu of the channel to which it is connected. See the
appropriate chapter of this manual for that card type.
2.5 Calibrate the Transducers to Their
Channels
You can skip this step if:
• YouareusingatransducerequippedwithSignature Calibra-
tion, or
• Thetransducerandinstrumentwerepurchasedtogetherand
set up by Honeywell.
Otherwise, you must choose a calibration method (e.g. Shunt
Calibration, mV/V Calibration, or Known Load Calibration) ap-
propriate for your application and use the SETUP menu for that
channel to calibrate the channel to the transducer. See the appro-
priate chapter of this manual for that card type.
2.6 The SC Series Instrument is Ready
for Use
See “RUN Mode” on page 6 for information on how to operate the
instrument while it is in the RUN mode.
Apply some test stimulus on the transducer to observe changes
in the display.