22 Honeywell Sensing and Control
Signal Conditioning, Self Calibrating Digital Indicators
Rev. G, 008-0608-00
7.4.6 TRANSMIT TEST Menu Item
When this menu item is selected, the instrument immediately
transmits the message “ADDRESS nn TEST” where “nn” is the two-
character address of the instrument. Then the message “MESSAGE
SENT” is shown on the display. This helps detect wiring or other
problems with serial communications from the instrument to the
computer or PLC.
7.4.7 LEAVE MENU Menu Item
When the menu item is displayed, press [ENTER] to leave this
menu. Press [EXIT] to return to the RUN mode.
To Next Page
Loading...
