Honeywell SC Series - Moving through SETUP Menus; Exiting the SETUP Menu Mode; Table 3-1: Navigating the Menus

8 Honeywell Sensing and Control
Signal Conditioning, Self Calibrating Digital Indicators
Rev. G, 008-0608-00
3.5.3 Moving Through SETUP Menus and
Menu Items
The following table shows how to move though menus and menu
items, and how to display or change the setting of a particular
item.
Table 3-1: Navigating the Menus
Button Action
[UP] or
[DOWN]
Scroll through available menus, sub-menus or
menu items
[ENTER] Select a menu, sub-menu or menu item
[EXIT] If changing a setting: abandons changes to a
menu item otherwise: leaves the SETUP mode
To change the setting of a menu item:
• Press[ENTER]todisplaythecurrentsetting,whichispre-
ceded by the ‘*’ character. Press [UP] or [DOWN] until you
see the setting you want. To abandon changes, press [EXIT].
To accept the new setting and move to the next item, press
[ENTER].
3.5.4 Exiting the SETUP Menu mode
To leave SETUP mode and return to the RUN mode, press [EXIT]
at any time.