Honeywell SmartLine ST 700 - Page 179

Revision 12 ST 700 SmartLine Pressure Transmitters User’s Manual Page 163
LRV Corrects
[11LRVCOR]
Calibration Methods
Perform an input calibration
correction by applying process
input at the configured LRV
level.
Press  to
enter menu
selection.
Press  to
initiate
action.
URV Corrects
[12URVCOR]
Calibration Methods
Perform an input calibration
correction by applying process
input at the configured URV
level.
Press  to
enter menu
selection.
Press  to
initiate
action.
Reset Corrects
[13RSTCOR]
Calibration Methods
Executing this selection resets
the Zero, LRV, URV, Cal Low,
Cal High and Barometric
Standard Corrects back to
factory values.
Press  to
enter menu
selection.
Press  to
initiate
action.
Tag Id
[14TAGID]

Character string of device tag
text for display.
x = any Alphanumeric value
Press  to
enter menu
selection
 to select
alphanumeric
character.
 to enter
and shift to
the next
character to
the right
Device
Firmware
[15DEVFW]

Menu item shows the current
Firmware version of the device.
x = any numeric value.
Menu to
select from
list
 to enter
Sensor
Firmware
[16SENFW]

Menu item shows the current
Firmware version of the
sensor.
x = any numeric value
Menu to
select from
list
 to enter
PV Damping
[17PVDAMP]
##.#
Enter a value for damping of
the device output. Entries may
be any value from 0.00 to
32.00 seconds.
Press  to
enter menu
selection
 to select
number.
 to enter
and shift to
the next digit
to the right