Pressure Transfer function:
Select the pressure transfer
function for calculated
output: Linear: (output
scaled linearly per
configured range) Square
Root: (output scaled as
square root conversion per
configured range – for flow
measurements)
Low Flow Cutoff Mode:
For Square Root (Transfer
function) configurations only,
choose the operating mode
to determine the low flow
cutoff breakpoint: Dual
slope: (breakpoint
determined by dual slope
calculation) User
configuration: (breakpoint
defined by user)
Zero Flow: Sets analog
output to 4mA when square
root / flow is below user
defined flow cutoff value.
Note: Sets loop output to low
saturation when the
differential pressure is below
–10%Flow.
To Next Page
Loading...
