Honeywell SmartLine ST 700 - Page 70

Page 54 ST 700 SmartLine Pressure Transmitters User’s Manual Revision 13
DAC Zero Trim
[5ZEROTR]
Note: Loop must be
removed from
Automatic Control
DAC Zero Trim
This selection allows the loop
zero output 4mA value to be
trimmed.
Note: You must connect a current
meter to the transmitter to monitor
the loop output.
Press  to
enter menu
selection
 Menu to
select
number.
 to enter
and shift to
the next digit
to the right
DAC Span Trim
[6SPANTR]
Note: Loop must be
removed from
Automatic Control
DAC Span Trim
This selection allows the loop
span output 20mA value to be
trimmed.
Note: You must connect a current
meter to the transmitter to monitor
the loop output.
Loop Test
[7 LPTEST]
Note: Loop must be
removed from
Automatic Control
Loop Test
12.000
This selection allows the user to
force the DAC output to any value
between 3.8 and 20.8 mA.
Note: This selection will put the
DAC into Fixed Output Mode, as
indicated by the flashing output
value. Navigation away from this
menu item will return the loop to
Normal (Automatic) Mode.
Press  to
enter menu
selection
 to select
number.
 to enter
and shift to
the next digit
to the right
Set LRV
[ 8SETLRV]
Set LRV
Executing this selection
performing for Zero operation.
Note: The PV value shown in
bottom line will be available in
Pressure Units (Simple Display
pressure unit)
Press  to
enter menu
selection
Press  to
initiate action
Set URV
[ 9SETURV]
Set URV
Executing this selection for Span
operation
Note: The PV value shown in
bottom line will be available in
Pressure Units (Simple Display
pressure unit)
Contrast
[10CNTRST]
Contrast level
Adjust the LCD contrast level.
Range from » (1) to
»»»»»»»»» (7)
Default: »»»»»»» (7)
Press  to
enter Menu
selection
Menu to
select level.
 to Enter