TR80 - Installation and Operation Guide3
1.3.2 Steps to install TR80 Wall module:
1.Switch OFF the power supply before initiating the TR80 installation.
2.Loosen the bottom screw a few turns.
3.Separate front panel and base by pulling out from the bottom, to do the wiring.
Caution: Electrical Shock or Equipment Damage Hazard. Can shock
individuals or short equipment circuitry.
Disconnect power supply before Installation.
Caution: Equipment Damage Hazard. Electrostatic discharge can short
equipment circuitry.
Ensure that you are properly grounded before handling the unit.
To Next Page
Loading...
