Honeywell TR80

20TR80 - Installation and Operation Guide
•Cleaning
Long press and to enter in cleaning mode. This mode prevents accidental
activation of functions while wiping the glass front.
•Dark
Depending on configuration this state can be activated by the power key and/or
on timeout. In this state everything is off (dark) on the device.
2.2 Access Level
To prevent unauthorized or accidental changes to the sytem, the device has a
“locked” state. Typical use-case is public areas where it is not desired for any pass-
erby to change setpoint or control lights.
The device enters locked state on a timeout (no buttons tapped for a while).
Different installations may require different scenarios for locking or unlocking the
device. Therefore, the device can be configured to operate in 4 different access lev-
els. The allowed states and their sequence for each configuration are as follows:
• Default access level : Sleep << >>Operational
•Simple access level : Sleep << >> Display Only <<- key combination -
>>Operational
• Secure access level : Sleep << >> Display Only <<- enter passkey ->>Operational
•No Access Level : Sleep << >> Display Only
2.3 Activating The Screen
The device may switch to sleep or dark state, if no action is taken in a defined time
span. In this state screen appears to be black-out. Tap any key on the keypad to
activate the screen.