22TR80 - Installation and Operation Guide
•Use to scroll between available values. Each value will be displayed
together with unit and sequence number.
•To hold any parameter on display long press ok key for 2 sec.
•Tap OK again to return to Operating mode.
2.5 Adjusting Temperature
when the device is unlocked user can change the temperature setpoint value. The
procedure to change the temperature setpoint value is as follows:
1.Tap , to enter in temperature Setting mode.
The screen shows the currently active setpoint (flashing).
Note:If setpoint change is disabled by the controller, then are disabled.
2.Tap to set desired temperature value.
3.Tap to save new setpoint value and exit.
Note:Tap , to exit without saving the changes and retain the previous set point value. In
case of timeout, it will exit the mode without saving the changes.
2.5.1 Changing The Temperature Unit
The temperature unit can be changed by pressing the temperature key if the device
is in ready state. Depending on configuration, this may require a long press.
Note:In some configurations, unit change may be disabled. Contact Service engineer to
enable it.
To Next Page
Loading...
