Honeywell TR80

26TR80 - Installation and Operation Guide
2.7.2.1 Overriding the occupancy mode
The user can override the automatically determined mode, if configuration allows.
when an user override is active, the occupancy symbol is blinking.
1.Tap to change the occupancy mode.
The display will show blinking text “AUTO”.
2.Tap to select the desired override occupancy mode.
3.Set the Bypass time in minutes if Bypass occupancy mode is selected or set the
Holiday period in number of days if Holiday Mode is selected.
4.Tap to exit without saving press.
5.Tap to activate and Save the selected override occupancy mode.
Note:The availability of options and mode depend on the device configuration.
2.8 Selecting / Overriding HVAC mode
The HVAC modes can be changed from wall module depending on the configura-
tion. Below methods are used to change the HVAC mode such as:
•Simple operation : Wall module user determines the HVAC mode
•Advanced operation: HVAC mode is determined in the controller. The user can
temporarily override the automatically determined mode.
HolidayThe user has overridden the automatic mode and switched the system to
building protection mode temporarily.
The display shows unoccupied symbol with scrolling text "Holiday for ...
days"
Occupancy StatusDescription