TR80 - Installation and Operation Guide25
2.7.2 Advanced Occupied/ unoccupied selection
In this mode, occupancy status is set by the master controller by considering vari-
ous factors like time schedule, motion sensor, a key-card system etc.
The various possible occupancy status are indicated on the screen as shown in the
below table.
Occupancy StatusDescription
OccupiedRoom is occupied and would typically operate in comfort mode.
The display will show occupancy symbol at the right bottom corner.
UnoccupiedRoom is unoccupied would typically operate in a building protection mode.
The display shows unoccupied symbol with text” AWAY”.
StandbyRoom is not occupied yet, it is kept in ready to occupy condition.
The display shows unoccupied symbol with scrolling text "STAND BY".
BypassThe user has overridden the automatic mode and switched the system to
comfort mode temporarily.
The display shows occupied symbol with scrolling text "Comfort for ... mins"
To Next Page
Loading...
