Honeywell TR80

62TR80 - Installation and Operation Guide
Note:Config from MAster controller details will be available in Master Controller
documents.
13External sensor
type
enum"0: NONE
1: NO contact
2: NC contact
3: 0-10 Vdc
4: 2-10 Vdc
5: Raw Ohms
6: NTC10K
7: NTC20K"
0NO : 0=open, 1 = closed
NC : 0= closed, 1 = open
14On-board sensor
temp offset
signed-10.0 … +10.0 K0
15On-board humidity
sensor offset
signed-10 … +10 %Rh0
16Dnd Mur enableenum"0: disabled
1: DnD enable
2: MuR enable
3: Dnd/Mur enable"
1
999Reset to defaultsbool0Resets some settings to default values.
Primarily modbus comms settings.
Exact list to be compiled later
Config
parameter
number
Name
Type/
Unit
Range
(min-Max)
DefaultNotes