5/00 UDC3300 Expanded Model: DC330E User Manual vii
Tables
Table 1-1 Function of Keys ____________________________________________________2
Table 2-1 Permissible Wiring Bundling ___________________________________________5
Table 2-2 Input 2 Jumper Selections_____________________________________________9
Table 2-3 Control Relay Contact Information _____________________________________18
Table 2-4 Alarm Relay Contact Information_______________________________________18
Table 3-1 Configuration Procedure _____________________________________________22
Table 3-2 Loop 1 Tuning Group Function Prompts _________________________________23
Table 3-3 Loop 2 Tuning Group Function Prompts _________________________________25
Table 3-4 SP Ramp Function Prompts __________________________________________27
Table 3-5 Accutune Group Function Prompts _____________________________________29
Table 3-6 Algorithm Group Function Prompts _____________________________________30
Table 3-7 Output Algorithm Group Function Prompts _______________________________34
Table 3-8 Input 1 Group Function Prompts _______________________________________36
Table 3-9 Input 2 Group Function Prompts _______________________________________37
Table 3-10 Input 3 Group Function Prompts ______________________________________39
Table 3-11 Control Group Function Prompts______________________________________40
Table 3-12 Loop 2 Control Parameters Set Up Group ______________________________42
Table 3-13 Options Group Function Prompt ______________________________________44
Table 3-14 Communications Group Function Prompts ______________________________45
Table 3-15 Alarms Group Function Prompts ______________________________________47
Table 3-16 Display Group Function Prompts______________________________________49
Table 3-17 Maintenance Group Function Prompts _________________________________50
Table 4-1 Lower Display Key Parameter Prompts__________________________________54
Table 4-2 Error Messages ____________________________________________________55
Table 4-3 Procedure for Starting Up the Controller_________________________________56
Table 4-4 Setpoint Selection Indication __________________________________________58
Table 4-5 Procedure for Selecting Two Sets of Tuning Constants _____________________58
Table 4-6 Procedure for Setting Switchover Values ________________________________58
Table 4-7 Procedure for Setting Tuning Constant Values____________________________59
Table 4-8 Procedure for Switching PID SETS from the Keyboard _____________________59
Table 4-9 Procedure for Displaying or Changing the Alarm Setpoints __________________60
Table 4-10 Control Loops Selections____________________________________________63
Table 4-11 Two Loop Functionality and Restrictions (Models DC330E-EE-2XX or
DC330E-EE-5XX) _________________________________________________64
Table 4-12 Two Loop Functionality and Restrictions (Models DC330E-KE-2XX or
DC330E-KE-5XX) _________________________________________________65
Table 4-13 Procedure for Selecting 2-loop Algorithm _______________________________66
Table 4-14 Procedure for Selecting Output Algorithm_______________________________66
Table 4-15 Procedure for Selecting Control Parameters_____________________________66
Table 4-16 Procedure for Selecting Tuning Parameters _____________________________67
Table 4-17 Digital Display Indication—Two Loops _________________________________67
Table 4-18 Procedure for Displaying the 3PSTEP Motor Position _____________________69
Table 4-19 Digital Input Option Action on Contact Closure ___________________________72
Table 4-20 Digital Input Combinations “DIG IN1” or “DIG IN2” ________________________74
Table 4-21 Accutune Rules and Regulations _____________________________________75
Table 4-22 Procedure for Starting TUNE (Demand) Tuning __________________________76
Table 4-23 Procedure for Using TUNE at Start-up for Duplex ________________________77
Table 4-24 Procedure for Using SP Tuning at Start-Up _____________________________77
To Next Page
Loading...
Need help?
General
