vi UDC3300 Expanded Model: DC330E User Manual 5/00
4.5 Setpoints......................................................................................................................57
4.6 Using Two Sets of Tuning Constants ...........................................................................58
4.7 Alarm Setpoints............................................................................................................60
4.8 Two Loops of Control...................................................................................................60
4.9 Monitoring Two Loops of Control..................................................................................67
4.10 Operating Two Loops of Control ..................................................................................68
4.11 Three Position Step Control Algorithm .........................................................................69
4.12 Input Math Algorithms ..................................................................................................69
4.13 Digital Input Option (Remote Switching).......................................................................72
4.14 Fuzzy Overshoot Suppression .....................................................................................74
4.15 Accutune......................................................................................................................74
4.16 Entering a Security Code .............................................................................................79
4.17 Carbon Potential ..........................................................................................................80
4.18 Health Watch ...............................................................................................................81
5. SETPOINT RATE/RAMP/SOAK PROGRAM OPERATION ................................83
5.1 Setpoint Ramp Rate.....................................................................................................83
5.2 Single Setpoint Ramp ..................................................................................................83
5.3 Setpoint Ramp/Soak Programming Option ..................................................................85
6. APPENDIX A – ENVIRONMENTAL AND OPERATING CONDITIONS ..............93
7. APPENDIX B – MODEL SELECTION GUIDE.....................................................95
8. APPENDIX C – CONFIGURATION RECORD SHEET........................................97
9. APPENDIX D – POSITION PROPORTIONAL CALIBRATION .........................101
9.1 Position Proportional Control Output Calibration ........................................................101
10. APPENDIX E – INPUT RANGES.......................................................................105
To Next Page
Loading...
Need help?
General
