Honeywell
37
Figure 7-12 Cascade connectionⅡ
NETWORK
Cascade Setup
Refer to Cascade on page 16 to set the cascade control.
In
Figure 4-55, press Ent and the following figure is displayed.
Figure 7-13 KBD Mode – Master
Figure 7-14 KBD Mode – Slave
If the keyboard is the master, in
Figure 7-13 press Ent to confirm the selection.
If the keyboard is the slave, in
Figure 7-14 press Ent to confirm the selection.
In
Figure 4-56, press Ent and set up the IP address.
The slave’s IP address must be the same to the master’s address.
PTZ Control (Direct Control)
Keyboard Setup
For connecting of Ultrakey Lite and PTZ, refer to Figure 7-3.
Certain settings should be done to use the direct control of PTZ with Ultrakey Lite.
• Set COM1 (in Figure 4-10) according to the table below:
To Next Page
Loading...
