Standalone Mode
38
Type
RS485
Baud Rate
1200, 9600, 19200 and so on
Parity
None/even/odd
Data
7/8 bit
Stop
1/2 bit
• In Standalone main menu (in Figure 7-1), press Select, and rotate the slider to enter
“PTZ” Settings or Press PTZ. You can set PTZ Name, Address and Protocol.
Figure 7-15 PTZ set
Camera Selecting
After keyboard setup and return to standalone main menu.
To select a camera for control, enter the camera number (1-128) using the numeric keypad
and press Camera.
Operations
Pan/Tilt
Use the joystick to control (pan and tilt) the camera. Move the joystick up and down for Tilt
functions and left and right for pan functions.
Zoom
Rotate the joystick knob clockwise/counterclockwise for zoom in/out functions.
Iris
Adjust the iris by pressing Iris (+) and Iris (-).
Focus
Press the Focus (+) or Focus (-) keys to manually focus the lens.
Preset
Program preset: Input number, press View, and then press Enter.
Run preset: Press the View, input number, and then press Enter.
PTZ
The PTZ call is used in Diamond protocol to control certain features of the KD6/HD6 PTZ
camera. Press PTZ call and the following figures are displayed by rotate the slider, and Press
Slider_Right to select.
Figure 7-16 PTZ – Auto Iris
To Next Page
Loading...
