Web System
44
Serial Port Configuration
Click Serial Port Configuration in the left pane and the following figure is displayed:
Figure 8-8 Serial Port Configuration
Serial Port1 Settings
• Baud Rate – select the proper baud rate of for the serial port.
• Parity – set the parity.
• Stop Bits – select the proper stop bit.
• Data Bits – select the proper data bit.
• Serial Mode – select the proper mode for the serial port.
The same configuration can be made in “Serial Port2 Settings” section.
Click Apply to save the configuration; Cancel to give up the configuration; Default to restore
all default values.
IP Configuration
Click IP Configuration in the left pane and the following figure is displayed:
Figure 8-9 IP Configuration
To Next Page
Loading...
