HP 54710A - Page 138

YRange
YRange is the voltage across eight vertical divisions of the
display. The default value is 1.60000E-001.
YOffset
YOffset is the voltage at the center of the display. The default
value is 0.
Date
Date is the date when the waveform was acquired. The default
value is 10 AUG 1992
Time
Time is the time when the waveform was acquired. The default
value is 01:00:00
Frame
Frame is the model and serial number of the mainframe which
acquired the waveform. The default value is 54720A:314A00000.
Module
Module is the model and serial number of the plug-in used in
the mainframe to acquire the waveform. The default value is empty
:314A00000.
Acq mode
Acquisition mode is the sampling mode used to acquire the
waveform, either real time or equivalent time. The default value is real
time.
Completion
Completion represents the percent of the time buckets in
the waveform record that contain data. The number of time buckets is
equal to the number of points in the waveform record. Completion is
ignored when it is read back into the oscilloscope. The default value is 0.
X Units
X units is the horizontal scaling units set in the channel menu:
unknown, Volt, second, constant, or Ampere. The default value is
unknown.
Y Units
Y units is the vertical scaling units set in the channel menu:
unknown, Volt, second, constant, or Ampere. The default value is
unknown.
Max bandwidth
Maximum bandwidth is an estimation of the maximum
bandwidth limit of the source signal. The default value is 0.
Min bandwidth
Minimum bandwidth is an estimation of the minimum
bandwidth limit of the source signal. The default value is 0.
Disk Menu
File Format
8–17