HP 5820X Switch - Upgrading PSE Processing Software in Service

92
To apply the PoE profile in system view:
To do…
Use the command… Remarks
1. Enter system view.
system-view —
2. Apply the PoE profile to one
or multiple PoE interfaces.
apply poe-profile { index index |
name profile-name } interface
interface-range
Required
To apply the PoE profile in interface view:
To do… Use the command… Remarks
1. Enter system view.
system-view —
2. Enter PoE interface view.
interface interface-type interface-
number
—
3. Apply the PoE profile to the
current PoE interface.
apply poe-profile { index index |
name profile-name }
Required
CAUTION:
A PoE profile can be applied to multiple PoE interfaces but a PoE interface can only be applied with
one PoE profile.
Upgrading PSE processing software in service
You can upgrade the PSE processing software in service in either of the following two modes:
• refresh mode—enables you to update the PSE processing software without deleting it. You can
upgrade the PSE processing software in the refresh mode through the command line.
• full mode—deletes the PSE processing software and reloads it. If the PSE processing software is
damaged (you can execute none of PoE commands successfully), you can upgrade the PSE
processing software in full mode to restore the PSE function.
In-service PSE processing software upgrade may be unexpectedly interrupted (for example, an error
results in device reboot). If you fail to upgrade the PSE processing software in full mode after reboot, you
can power off the device and restart it before upgrading it in full mode again. After upgrade, the new
PSE processing software take effect.
To upgrade the PSE processing software in service:
To do… Use the command… Remarks
1. Enter system view.
system-view —
2. Upgrade the PSE processing
software in service.
poe update { full | refresh }
filename pse pse-id
Required