HP 5820X Switch - Configuring Ipv6 Netstream Aggregation Data Export Example

219
[SwitchA-vlan2000] quit
[SwitchA] interface vlan-interface 2000
[SwitchA-Vlan-interface2000] ip address 12.110.2.1 255.255.0.0
[SwitchA-Vlan-interface2000] quit
# Configure the destination IP address and port number for IPv6 NetStream data export as 12.110.2.2
and 5000.
[SwitchA] ipv6 netstream export host 12.110.2.2 5000
Configuring IPv6 NetStream aggregation data export example
Network requirements
As shown in Figure 79, configure IPv6 NetStream on Switch A so that:
• Switch A exports IPv6 NetStream traditional data to port 5000 of the NetStream server at 4.1.1.1/16.
• Switch A performs IPv6 NetStream aggregation in the modes of protocol-port, source-prefix,
destination-prefix and prefix. Then aggregation data is sent to the destination address with UDP port
3000, 4000, 6000, and 7000 for different modes.
NOTE:
All routers in the network are running IPv6 EBGP. For more information about IPv6 BGP, see
Layer 3—
IP Routing Configuration Guide
.
Figure 79 Network diagram for configuring IPv6 NetStream aggregation data export
4.1.1.1/16
IPv6 Network
Switch A
AS 100
IPv6 Network
GE1/0/1
NetStream Server
Configuration procedure
# Enable NetStream in both the inbound and outbound directions of GigabitEthernet 1/0/1.
<SwitchA> system-view
[SwitchA] interface GigabitEthernet 1/0/1
[SwitchA-GigabitEthernet1/0/1] ip netstream inbound
[SwitchA-GigabitEthernet1/0/1] ip netstream outbound
[SwitchA-GigabitEthernet1/0/1] quit
# Configure the destination address and destination port for IPv6 NetStream common data export.
[SwitchA] ipv6 netstream export host 4.1.1.1 5000
# Configure the aggregation mode as protocol-port, and in aggregation view configure the destination
host for the IPv6 NetStream protocol-port aggregation data export.
[SwitchA] ipv6 netstream aggregation protocol-port