HP 5820X Switch - Configuring Mirroring Ports for the Local Mirroring Group; Configuring Mirroring Cpus for the Local Mirroring Group

169
Configuring mirroring ports for the local mirroring group
You can configure a list of mirroring ports for a mirroring group at a time in system view, or only assign
the current port to it as a mirroring port in interface view. To assign multiple ports to the mirroring group
as mirroring ports in interface view, repeat the step.
Configuring mirroring ports in system view
To do… Use the command… Remarks
1. Enter system view.
system-view —
2. Configure mirroring ports.
mirroring-group group-id
mirroring-port mirroring-port-list
{ both | inbound | outbound }
Required.
By default, no mirroring port is
configured for a mirroring group.
Configuring a mirroring port in interface view
To do… Use the command… Remarks
1. Enter system view.
system-view —
2. Enter interface view.
interface interface-type interface-
number
—
3. Configure the current port as
a mirroring port.
[ mirroring-group group-id ]
mirroring-port { both | inbound |
outbound }
Required.
By default, a port does not serve
as a mirroring port for any
mirroring group.
NOTE:
A mirroring group can contain multiple mirroring ports.
Configuring mirroring CPUs for the local mirroring group
To do… Use the command… Remarks
1. Enter system view.
system-view —
2. Configure mirroring CPUs.
mirroring-group group-id
mirroring-cpu slot slot-number-list
{ both | inbound | outbound }
Required.
By default, no mirroring CPU is
configured for a mirroring group.
NOTE:
A mirroring group can contain multiple mirroring CPUs.