HP 5820X Switch - Configuring Ipv6 Netstream Aggregation Data Export

215
To do… Use the command… Remarks
3. Enable NetStream.
ip netstream { inbound |
outbound }
Required.
Disabled by default.
4. Exit to system view.
quit —
5. Configure the destination
address for the IPv6
NetStream traditional
data export.
ipv6 netstream export host ip-
address udp-port [ vpn-instance
vpn-instance-name ]
Required.
By default, no destination address is
configured, in which case, the IPv6
NetStream traditional data is not
exported.
6. Configure the source
interface for IPv6
NetStream traditional
data export.
ipv6 netstream export source
interface interface-type interface-
number
Optional.
• By default, the interface where the
NetStream data is sent out (the
interface connects to the
NetStream server) is used as the
source interface.
• HP recommends you connect the
network management interface to
the NetStream server and
configure it as the source interface.
7. Limit the data export rate.
ipv6 netstream export rate rate
Optional.
No limit by default.
Configuring IPv6 NetStream aggregation data export
IPv6 NetStream aggregation can be implemented by software or hardware. The term of NetStream
aggregation refers to the implementation by software, unless otherwise noted.
The IPv6 NetStream hardware aggregation directly merges the statistics of data flows at the hardware
layer according to the aggregation criteria of the specific aggregation mode, and stores the IPv6
NetStream hardware aggregation data in the cache. When the timer for the hardware aggregation entry
expires, the data is exported. This greatly reduces the resource consumption by IPv6 NetStream
aggregation.
Without hardware aggregation configured, the IPv6 NetStream data aggregation is implemented by
software.
To configure IPv6 NetStream aggregation data export:
To do… Use the command… Remarks
1. Enter system view.
system-view —
2. Enter Layer 2 Ethernet
interface view or Layer 3
Ethernet interface view.
interface interface-type
interface-number
—
3. Enable NetStream.
ip netstream { inbound |
outbound }
Required.
Disabled by default.
4. Exit to system view.
quit —