HP 5820X Switch - Configuring the NQA Server

13
Task Remarks
Configuring ICMP echo tests
Configuring DHCP tests
Configuring DNS tests
Configuring FTP tests
Configuring HTTP tests
Configuring UDP jitter tests
Configuring SNMP tests
Configuring TCP tests
Configuring UDP echo tests
Configuring voice tests
Configuring an NQA test group
Configuring DLSw tests
Required
Use any of the approac
hes
Configuring the collaboration function Optional
Configuring threshold monitoring Optional
Configuring the NQA statistics collection function Optional
Configuring the history records saving function Optional
Configuring optional parameters for an NQA test group Optional
Scheduling an NQA test group Required
Configuring the NQA server
To perform TCP, UDP echo, UDP jitter, or voice tests, configure the NQA server on the peer device. The
NQA server responses to the probe packets sent from the NQA client by listening to the specified
destination address and port number.
To configure the NQA server:
To do… Use the command… Remarks
1. Enter system view.
system-view —
2. Enable the NQA server.
nqa server enable
Required.
Disabled by default.
3. Configure the listening
service.
nqa server { tcp-connect | udp-
echo } ip-address port-number
Required.
The destination IP address and port
number must be the same as those
configured on the NQA client. A
listening service must be unique on
the NQA server.