HP 5820X Switch - Configuring the DNS Server; Configuring the ACS Server; Configuring Cpes

127
Configuring the DNS server
On the DNS server, you must bind the URL address to the IP address of the ACS server to ensure that
CPEs can obtain the IP address of the ACS through the DNS function.
Configuring the ACS server
An ACS performs auto-configuration of a CPE through remote management. For the primary configurable
parameters, see “Configuration parameter deployment.
” For more information on configuring the ACS
server, see the user manual that came with your ACS server.
Configuring CPEs
You can set CWMP parameters at the CLI.
NOTE:
The HP 5800 and 5820X switches operate as CPEs in a CWMP-enabled network, so the followin
g
only
describes the configuration on CPEs.
Complete these tasks to configure CWMP:
Task Remarks
Enabling CWMP Required
Configuring the ACS URL Required
Configuring the
ACS server
Configuring the ACS username and
password
Optional
Configuring the CPE username and
password
Optional
Configuring the CWMP connection
interface
Optional
Configuring the CWMP connection
interface
Optional
Configuring the maximum number of
attempts made to retry a connection
Optional
Configuring CPE
attributes
Configuring the close-wait timer of the CPE Optional