174
Configuring the remote probe VLAN for the remote source mirroring group
To do… Use the command… Remarks
1. Enter system view.
system-view —
2. Configure the remote probe
VLAN.
mirroring-group group-id remote-
probe vlan rprobe-vlan-id
Required.
By default, no remote probe
VLAN is configured for a
mirroring group.
NOTE:
• A VLAN can only be used by one mirroring group.
• HP recommends you use the remote probe VLAN for port mirroring exclusively.
• To remove the VLAN configured as a remote probe VLAN, you must remove the remote probe VLAN
with undo mirroring-group remote-probe vlan command first. Removing the probe VLAN can
invalidate the remote source mirroring group.
Configuring a remote destination mirroring group (on the
destination device)
To configure a remote destination mirroring group, make the following configurations on the destination
device.
Creating a remote destination mirroring group
To do… Use the command… Remarks
1. Enter system view.
system-view —
2. Create a remote destination
mirroring group.
mirroring-group group-id remote-
destination
Required.
By default, no mirroring group
exists.
Configuring the monitor port for the remote destination mirroring group
You can configure the monitor port for a mirroring group in system view, or assign the current port to a
mirroring group as the monitor port in interface view. The two modes lead to the same result.
• Configuring the monitor port in system view
To do… Use the command… Remarks
1. Enter system view.
system-view —
2. Configure the monitor port.
mirroring-group group-id monitor-
port monitor-port-id
Required.
By default, no monitor port is
configured for a mirroring group.
To Next Page
Loading...
