113
Configuring the RMON Ethernet statistics function
To configure the RMON Ethernet statistics function:
To do…
Use the command… Remarks
1. Enter system view.
system-view —
2. Enter Ethernet interface view.
interface interface-type interface-number —
3. Create an entry in the RMON
statistics table.
rmon statistics entry-number [ owner text ] Required
NOTE:
• Only one statistics entry can be created on one interface.
• Up to 100 statistics entries can be created for the device. When the number of statistics entries
exceeds 100, the creation of a new entry fails.
Configuring the RMON history statistics function
To configure the RMON history statistics function:
To do… Use the command… Remarks
1. Enter system view.
system-view —
2. Enter Ethernet interface view.
interface interface-type interface-number —
3. Create an entry in the RMON
history control table.
rmon history entry-number buckets number
interval sampling-interval [ owner text ]
Required
NOTE:
• The
entry-number
must be globally unique and cannot be used on another interface; otherwise, the
operation fails.
• You can configure multiple history entries on one interface, but the values of the
entry
-
number
arguments must be different, and the values of the
sampling
-
interval
arguments must be different too;
otherwise, the operation fails.
• Up to 100 history entries can be created for the device.
• When you create an entry in the history table, if the specified buckets
number
argument exceeds the
history table size supported by the device, the entry is created. However, the validated value of the
buckets
number
argument that corresponds to the entry is the history table size supported by the
device.
To Next Page
Loading...
