28
Configuring threshold monitoring
Configuration prerequisites
Before you configure threshold monitoring, complete the following tasks:
• Configure the destination address of the trap message by using the snmp-agent target-host
command. For more information about the snmp-agent target-host command, see “SNMP
configuration commands.”
• Create an NQA test group and configure related parameters.
Configuring threshold monitoring
To configure threshold monitoring:
To do… Use the command… Remarks
1. Enter system view.
system-view —
2. Enter NQA test group view.
nqa entry admin-name operation-tag —
3. Enter test type view of the test
group.
type { dhcp | dlsw | dns | ftp | http | icmp-
echo | snmp | tcp | udp-echo | udp-jitter |
voice }
—
• Configure the device to send
traps to the network
management server under
specified conditions.
reaction trap { probe-failure consecutive-probe-
failures | test-complete | test-failure cumulate-
probe-failures }
• Configure a reaction entry for
monitoring the probe duration
of a test (not supported in UDP
jitter and voice tests)
reaction item-number checked-element probe-
duration threshold-type { accumulate
accumulate-occurrences | average |
consecutive consecutive-occurrences } threshold-
value upper-threshold lower-threshold [ action-
type { none | trap-only } ]
• Configure a reaction entry for
monitoring the probe failure
times (not supported in UDP
jitter and voice tests)
reaction item-number checked-element probe-
fail threshold-type { accumulate accumulate-
occurrences | consecutive consecutive-
occurrences } [ action-type { none | trap-
only } ]
• Configure a reaction entry for
monitoring packet round-trip
time (only supported in UDP
jitter and voice tests)
reaction item-number checked-element rtt
threshold-type { accumulate accumulate-
occurrences | average } threshold-value upper-
threshold lower-threshold [ action-type { none |
trap-only } ]
• Configure a reaction entry for
monitoring the packet loss in
each test (only supported in
UDP jitter and voice tests)
reaction item-number checked-element packet-
loss threshold-type accumulate accumulate-
occurrences [ action-type { none | trap-only } ]
• Configure a reaction entry for
monitoring one-way delay
jitter (only supported in UDP
jitter and voice tests)
reaction item-number checked-element { jitter-ds
| jitter-sd } threshold-type { accumulate
accumulate-occurrences | average } threshold-
value upper-threshold lower-threshold [ action-
type { none | trap-only } ]
Required.
Configure the device
to send traps.
No traps are sent to
the network
management server
by default.
To Next Page
Loading...
