218
NOTE:
The refresh frequency and interval can be both configured, and the template is resent when either of
the condition is reached.
Displaying and maintaining IPv6 NetStream
To do… Use the command… Remarks
Display the IPv6 NetStream
entry information in the cache
display ipv6 netstream cache [ verbose ] [ slot
slot-number ] [ | { begin | exclude | include }
regular-expression ]
Available in any view
Display information about IPv6
NetStream data export
display ipv6 netstream export [ | { begin |
exclude | include } regular-expression ]
Available in any view
Display the configuration and
status of the NetStream flow
record templates
display ipv6 netstream template [ slot slot-
number ] [ | { begin | exclude | include }
regular-expression ]
Available in any view
Clear the cache, and age out
and export all IPv6 NetStream
data
reset ipv6 netstream statistics Available in user view
Configuring IPv6 NetStream examples
Configuring IPv6 NetStream traditional data export example
Network requirements
As shown in Figure 78, configure IPv6 NetStream on Switch A to collect statistics on packets passing
through it. Configure the device to export IPv6 NetStream traditional data to UDP port 5000 of the
NetStream server at 12.110.2.2/16.
Figure 78 Network diagram for configuring IPv6 NetStream traditional data export
Configuration procedure
# Enable IPv6 NetStream in its inbound direction of GigabitEthernet 1/0/1.
<SwitchA> system-view
[SwitchA] ipv6
[SwitchA] interface GigabitEthernet 1/0/1
[SwitchA-GigabitEthernet1/0/1] ip netstream inbound
[SwitchA-GigabitEthernet1/0/1] quit
# Create VLAN 2000 and assign IP address 12.110.2.1 to VLAN-interface 2000.
[SwitchA] vlan 2000
To Next Page
Loading...
