17
To do… Use the command… Remarks
4. Specify the IP address of the
DNS server as the destination
address of DNS packets.
destination ip ip-address
Required.
By default, no destination IP
address is configured.
5. Configure the domain name
that needs to be translated.
resolve-target domain-name
Required.
By default, no domain name is
configured.
6. Configure optional
parameters.
See “Configuring optional
parameters for an NQA test group”
Optional.
NOTE:
A DNS test simulates the domain name resolution. It does not save the mapping between the domain
name and the IP address.
Configuring FTP tests
FTP tests of an NQA test group are used to test the connection between the NQA client and an FTP server
and the time necessary for the FTP client to transfer a file to or download a file from the FTP server.
Configuration prerequisites
Before you start FTP tests, configure the FTP server. For example, configure the username and password
that are used to log in to the FTP server. For more information about FTP server configuration, see
Fundamentals Configuration Guide.
Configuring FTP tests
To configure FTP tests:
To do… Use the command… Remarks
1. Enter system view.
system-view —
2. Enter NQA test group view.
nqa entry admin-name operation-
tag
—
3. Configure the test type as FTP
and enter test type view.
type ftp Required.
4. Specify the IP address of the
FTP server as the destination
address of FTP request
packets.
destination ip ip-address
Required.
By default, no destination IP
address is configured.
5. Configure the source IP
address of FTP request
packets.
source ip ip-address
Required.
By default, no source IP address is
specified.
The source IP address must be the
IP address of a local interface.
The local interface must be up;
otherwise, no FTP requests can be
sent out.
To Next Page
Loading...
