26
To do… Use the command… Remarks
10. Configure the size of the data
field in each probe packet.
data-size size
Optional.
By default, the probe packet size
depends on the codec type. The
default packet size is 172 bytes
for G.711A-law and G.711 μ-law
codec type, and is 32 bytes for
G.729 A-law codec type.
11. Configure the string to be
filled in the data field of each
probe packet.
data-fill string
Optional
By default, the string is the
hexadecimal number
00010203040506070809.
12. Configure the number of
probe packets to be sent
during each voice probe
operation.
probe packet-number
packet-number
Optional.
1000 by default.
13. Configure the interval for
sending probe packets during
each voice probe operation.
probe packet-interval packet-
interval
Optional.
20 milliseconds by default.
14. Configure the interval the
NQA client must wait for a
response from the server
before it regards the response
times out.
probe packet-timeout packet-
timeout
Optional.
5000 milliseconds by default.
15. Configure optional
parameters.
See “Configuring optional
parameters for an NQA test
group"
Optional.
NOTE:
Only one probe operation is performed in one voice test.
Configuring DLSw tests
DLSw tests of an NQA test group are used to test the response time of a DLSw device.
Configuration prerequisites
Before you start DLSw tests, enable the DLSw function on the peer device.
Configuring a DLSw test
To configure DLSw tests:
To do… Use the command… Remarks
1. Enter system view.
system-view —
2. Enter NQA test group view.
nqa entry admin-name operation-
tag
—
3. Configure the test type as
DLSw and enter test type view.
type dlsw Required.
To Next Page
Loading...
