HP 5820X Switch - Outputting System Information to a Log Host

235
To do… Use the command… Remarks
4. Enable the display of trap
information on a monitor
terminal.
terminal trapping
Optional.
Enabled by default.
Outputting system information to a log host
To do… Use the command… Remarks
1. Enter system view.
system-view —
2. Enable information center.
info-center enable
Optional.
Enabled by default.
3. Name the channel with a
specified channel number.
info-center channel channel-
number name channel-name
Optional.
See Table 9 for
default channel
names.
4. Configure the output rules of
the system information.
info-center source { module-name
| default } channel { channel-
number | channel-name } [ debug
{ level severity | state state } * |
log { level severity | state state } *
| trap { level severity | state
state } * ] *
Optional.
See “Default output rules of
system informat
ion.”
5. Specify the source IP address
for the log information.
info-center loghost source
interface-type interface-number
Optional.
By default, the source interface is
determined by the matched route,
and the primary IP address of this
interface is the source IP address
of the log information.
6. Configure the format of the
time stamp for system
information output to the log
host.
info-center timestamp loghost
{ date | iso | no-year-date |
none }
Optional.
date by default.
7. Set the format of the system
information sent to a log host
to UNICOM.
info-center format unicom
Optional.
HP by default.
8. Specify a log host and
configure the related output
parameters.
info-center loghost { ipv6 host-
ipv6-address | [ vpn-instance vpn-
instance-name ] host-ipv4-
address } [ port port-number ]
[ channel { channel-number |
channel-name } | facility local-
number ] *
Required
By default, the system does not
output information to a log host. If
you specify to output system
information to a log host, the
system uses channel 2 (loghost)
by default.
The value of the port-number
argument should be the same as
the value configured on the log
host, otherwise, the log host
cannot receive system
information.