31
Configuring optional parameters for an NQA test
group
Optional parameters for an NQA test group are only valid for tests in this test group.
Unless otherwise specified, the following optional parameters are applicable to all test types.
To configure optional parameters for an NQA test group:
To do… Use the command… Remarks
1. Enter system view.
system-view —
2. Enter NQA test group view.
nqa entry admin-name operation-
tag
—
3. Enter test type view of a test
group.
type { dhcp | dlsw | dns | ftp |
http | icmp-echo | snmp | tcp |
udp-echo | udp-jitter | voice }
—
4. Configure the description for a
test group.
description text
Optional.
By default, no description is
available for a test group.
5. Configure the interval
between two consecutive tests
for a test group.
frequency interval
Optional.
By default, the interval between
two consecutive tests for a test
group is 0 milliseconds. Only one
test is performed.
If the last test is not completed
when the interval specified by the
frequency command is reached, a
new test does not start.
6. Configure the number of
probe operations to be
performed in one test.
probe count times
Optional.
By default, one probe operation is
performed in one test.
Not available for voice tests. Only
one probe operation can be
performed in one voice test.
7. Configure the NQA probe
timeout time.
probe timeout timeout
Optional.
By default, the timeout time is
3000 milliseconds.
Not available for UDP jitter tests.
8. Configure the maximum
number of hops a probe
packet traverses in the
network.
ttl value
Optional.
20 by default.
Not available for DHCP tests.
9. Configure the ToS field in an
IP packet header in an NQA
probe packet.
tos value
Optional.
0 by default.
Not available for DHCP tests.
To Next Page
Loading...
