206
Figure 74 Recorded AS information varies with different keyword configuration
AS 20 AS 21
AS 22
AS 23
Enable NetStream
Include origin-as in the command.
AS 20 is recorded as the source AS and
AS 24 as the destination AS.
AS 24
Include peer-as in the command.
AS 21 is recorded as the source AS, and
AS 23 as the destination AS.
Configuring refresh rate for NetStream version 9 templates
Version 9 is template-based and supports user-defined formats, so the NetStream-enabled device needs to
resend a new template to the NetStream server for an update. If the version 9 format is changed on the
NetStream-enabled device and not updated on the NetStream server, the server is unable to associate the
received statistics with its proper fields. To avoid such situation, configure the refresh frequency and rate
for version 9 templates so that the NetStream server can refresh the templates on time.
To configure the refresh rate for NetStream version 9 templates:
To do… Use the command… Remarks
1. Enter system view.
system-view —
2. Configure the refresh frequency for
NetStream version 9 templates.
ip netstream export v9-template
refresh-rate packet packets
Optional.
By default, the version 9
templates are sent every 20
packets.
3. Configure the refresh interval for
NetStream version 9 templates.
ip netstream export v9-template
refresh-rate time minutes
Optional.
By default, the version 9
templates are sent every 30
minutes.
NOTE:
The refresh frequency and interval can be both configured, and the template is resent when either of
the condition is reached.