HP 5820X Switch - Cluster Member Management

152
To configure the destination MAC address of the cluster management protocol packets:
To do… Use the command… Remarks
1. Enter system view.
system-view —
2. Enter cluster view.
cluster —
3. Configure the destination
MAC address for cluster
management protocol
packets.
cluster-mac mac-address
Required.
The destination MAC address is
0180-C200-000A by default.
The following are the configurable
MAC addresses:
• 0180-C200-0000
• 0180-C200-000A
• 0180-C200-0020 through
0180-C200-002F
• 010F-E200-0002
4. Configure the interval to send
MAC address negotiation
broadcast packets.
cluster-mac syn-interval interval
Optional.
One minute by default.
CAUTION:
When you configure the destination MAC address for cluster management protocol packets:
• If the interval for sending MAC address negotiation broadcast packets is 0, the system automatically
sets it to 1 minute.
• If the interval for sending MAC address negotiation broadcast packets is not 0, the interval remains
unchanged.
Cluster member management
You can manually add a candidate device to a cluster, or remove a member device from a cluster.
If a member device needs to be rebooted for software upgrade or configuration update, remotely reboot
it through the management device.
Adding a member device
To do… Use the command… Remarks
1. Enter system view.
system-view —
2. Enter cluster view.
cluster —
3. Add a candidate device to
the cluster.
add-member [ member-number ]
mac-address mac-address
[ password password ]
Required
Removing a member device
To do… Use the command… Remarks
1. Enter system view.
system-view —