HP 5820X Switch - Enabling CWMP; Configuring the ACS Server; Configuring the ACS URL; Configuring the ACS Username and Password

128
Enabling CWMP
CWMP configurations can only take effect after you enable CWMP.
To enable CWMP:
To do… Use the command… Remarks
1. Enter system view.
system-view —
2. Enter CWMP view.
cwmp —
3. Enable CWMP.
cwmp enable
Optional.
By default, CWMP is enabled.
Configuring the ACS server
ACS server information includes ACS URL, username and password. The ACS server information is
included in the connection request when the CPE sends a connection request to the ACS. When the ACS
receives the request, if the parameter values in the request are consistent with those configured locally, the
authentication succeeds, and the connection is allowed to be established; otherwise, the authentication
fails, and the connection is not allowed to be established.
Configuring the ACS URL
To do… Use the command… Remarks
1. Enter system view.
system-view —
2. Enter CWMP view.
cwmp —
3. Configure the ACS URL.
cwmp acs url url
Required.
By default, no ACS URL is
configured.
NOTE:
You can only assign one ACS for a CPE and the ACS URL you configured overwrites the old one, if
any.
Configuring the ACS username and password
To do… Use the command… Remarks
1. Enter system view.
system-view —
2. Enter CWMP view.
cwmp —
3. Configure the ACS username
for connection to the ACS.
cwmp acs username username
Required.
By default, no ACS username is
configured for connection to the
ACS.