HP 5820X Switch - Enabling Netstream; Enabling Netstream on an Interface; Configuring Netstream Filtering and Sampling; Configuring Netstream Filtering

200
Enabling NetStream
Enabling NetStream on an interface
To do… Use the command… Remarks
1. Enter system view.
system-view —
2. Enter Layer 2 Ethernet
interface view or Layer 3
Ethernet interface view.
interface interface-type interface-number —
3. Enable NetStream on the
interface.
ip netstream { inbound | outbound }
Required.
Disabled by default.
NOTE:
NetStream can only be enabled on Layer 2 Ethernet interface or Layer 3 Ethernet interface.
Configuring NetStream filtering and sampling
Before you configure NetStream filtering and sampling, use the ip netstream command to enable
NetStream.
Configuring NetStream filtering
Configuring ACL-based NetStream filtering
To do… Use the command… Remarks
1. Enter system view.
system-view —
2. Enter Layer 2 Ethernet interface
view or Layer 3 Ethernet
interface view.
interface interface-type interface-number
—
3. Enable ACL-based NetStream
filtering in the inbound or
outbound direction of an
interface.
ip netstream filter acl acl-number
{ inbound | outbound }
Optional.
By default, no ACL is
referenced and IPv4
packets are not filtered.
NOTE:
• When NetStream filtering and sampling are both configured, packets are filtered first and then the
matching packets are sampled.
• An ACL must be created before being referenced by NetStream filtering. An ACL that is referenced by
NetStream filtering cannot be deleted or modified. For more information about ACLs, see ACL and
QoS Configuration Guide
.
Configuring QoS-based NetStream filtering
Use the netstream filter command to configure a NetStream filtering action for a traffic behavior by
specifying the following keywords: