HP 5820X Switch - Configuring SNMP Tests

21
To do… Use the command… Remarks
12. Configure the source IP
address for UDP jitter packets.
source ip ip-address
Optional.
By default, no source IP address is
specified.
The source IP address must be the
IP address of a local interface.
The local interface must be up;
otherwise, no probe packets can
be sent out.
13. Configure optional
parameters.
See “Configuring optional
parameters for an NQA test
group”
Optional.
NOTE:
The probe count command specifies the number of probe operations during one UDP jitter test. The
probe packet-number command specifies the number of probe packets sent in each UDP jitter probe
operation.
Configuring SNMP tests
SNMP tests of an NQA test group are used to test the time the NQA client takes to send an SNMP packet
to the SNMP agent and receive a response.
Configuration prerequisites
Before you start SNMP tests, enable the SNMP agent function on the device that serves as an SNMP
agent. For more information about SNMP agent configuration, see “Configuring SNMP.”
Configuring SNMP tests
To configure SNMP tests:
To do… Use the command… Remarks
1. Enter system view.
system-view —
2. Enter NQA test group view.
nqa entry admin-name operation-
tag
—
3. Configure the test type as
SNMP and enter test type
view.
type snmp Required.
4. Configure the destination
address of SNMP packets.
destination ip ip-address
Required.
By default, no destination IP
address is configured.
5. Specify the source port of
SNMP packets.
source port port-number
Optional.
By default, no source port number
is specified.