175
• Configuring the monitor port in interface view
To do… Use the command… Remarks
1. Enter system view.
system-view —
2. Enter interface view.
interface interface-type interface-
number
—
3. Configure the current port as
the monitor port.
[ mirroring-group group-id ]
monitor-port
Required.
By default, a port does not serve
as the monitor port for any
mirroring group.
NOTE:
• A mirroring group only contains one monitor port.
• To make sure that the port mirroring function works properly, do not enable STP, MSTP, or RSTP on
the monitor port.
• HP recommends you only use a monitor port for port mirroring. This is to make sure that the data
monitorin
device only receives and analyzes the mirrored traffic rather than a mix of mirrored traffic
and normally forwarded traffic.
• A port connected to an RRPP ring cannot be configured as the monitor port of a port mirroring
group.
Configuring the remote probe VLAN for the remote destination mirroring group
To do… Use the command… Remarks
1. Enter system view.
system-view —
2. Configure the remote probe
VLAN.
mirroring-group group-id remote-
probe vlan rprobe-vlan-id
Required.
By default, no remote probe
VLAN is configured for a
mirroring group.
NOTE:
• A VLAN can only be used by one mirroring group.
• HP recommends you use the remote probe VLAN for port mirroring exclusively.
• To remove the VLAN configured as a remote probe VLAN, you must remove the remote probe VLAN
with undo mirroring-group remote-probe vlan command first. Removing the probe VLAN can
invalidate the remote source mirroring group.
Assigning the monitor port to the remote probe VLAN
To do… Use the command… Remarks
1. Enter system view.
system-view —
2. Enter the interface view of the
monitor port.
interface interface-type interface-number —
For an access
port
port access vlan vlan-id
3. Assign the
port to the
probe
For a trunk port port trunk permit vlan
vlan-id
Required.
Use one of the
commands.
To Next Page
Loading...
