146
Task Remarks
Enabling the cluster function Optional
Deleting a member device from a cluster Optional
Configuring access between the management device and its member
devices
Optional
Adding a candidate device to a cluster Optional
Configuring topology management Optional
Configuring interaction for a cluster Optional
SNMP configuration synchronization function Optional
Configuring advanced
cluster functions
Configuring web user accounts in batches Optional
CAUTION:
• Disabling the NDP and NTDP functions on the management device and member devices after a
cluster is created will not cause the cluster to be dismissed, but will influence the normal operation of
the cluster.
• In a cluster, if a member device enabled with the 802.1X or MAC address authentication function has
other member devices connected to it, you must enable HW Authentication Bypass Protocol (HABP)
server on the device. Otherwise, the management device of the cluster cannot manage the devices
connected with it. Whether to enable HABP server on the management device enabled with the
802.1X or MAC address authentication depends on your device model. For more information about
the HABP, see HABP configuration
in the
Security Configuration Guide
.
• If the routing table of the management device is full when a cluster is established, which means that
entries with the destination address as a candidate device cannot be added to the routing table, all
candidate devices will be added to and removed from the cluster repeatedly.
• If the routing table of a candidate device is full when the candidate device is added to a cluster,
which means that the entry with the destination address as the management device cannot be added
to the routing table, the candidate device will be added to and removed from the cluster repeatedly.
To Next Page
Loading...
