HP 8360 - Page 29

l-37. Inside the Initiate State ............
l-38. Inside an Event Detection State ........
l-39. Inside the Sequence Operation State ......
l-40. The INIT Trigger Configuration ........
1-41. The TRIG Trigger Configuration ........
l-42. HP 8360 Simplified Trigger Model .......
A-l. ALC System Simplified Block Diagram .....
A-2. Typical External Leveling Hookup .......
C-l. Auxiliary Interface Connector .........
C-2. HP-IB Connector and Cable ..........
C-3. Interface Signals of the Source Module Connector .
F-l. Basic User Flatness Configuration Using an HP 437B
Power Meter ...............
F-2. User Flatness Correction Table as Displayed by the
Synthesizer ................
F-3. The Sources of ALC Calibration Correction Data .
F-4. Array Configuration when the Correction Data
Frequency Span is a Subset of the Synthesizer
Frequency Span ..............
M-l. ALC Block Diagram .............
M-2. Power Accuracy Over the AM Dynamic Range . .
M-3. FM Deviation and Rate Limits .........
M-4. ALC Block Diagram .............
M-5. Pulse Modulation System ...........
M-6. Video Feedthrough ..............
P-l. How (PRIOR) Works
...............
S-l. Connections Required for a Two-Tone Scalar
Network Analyzer Measurement System ...
3-l. AC Power Cables Available ..........
3-2. Rear Panel HP-IB Switch ...........
3-3. Removing the Side Straps and Feet .......
3-4. Chassis Slide Kit ...............
3-5. Rack Mount Flanges for Synthesizers with Handles
Removed .................
3-6. Rack Mount Flanges for Synthesizers with Handles
Attached
.................
4-l. Replacing the Line Fuse ............
4-2. Removing the Fan Filter ...........
l-106
l-108
l-109
l-110
l-111
l-111
A-5
A-8
c-7
c-9
c-11
F-6
F-7
F-8
F-9
M-13
M-16
M-18
M-20
M-20
M-22
P-11
S-65
3-5
3-7
3-11
3-12
3-14
3-16
4-4
4-5
Contents-16
HP 8360
User’s Handbook