1
GETTING
STARTED
What Is In This
Chapter
This chapter contains information on how to use the HP 8360 Series
Synthesized Sweeper. The information is separated into three
sections.
Basic
Advanced
Programming
For the novice user unfamiliar with the HP 8360
Series Synthesized Sweepers. This section describes
the basic features of the synthesizer.
For the user familiar with synthesizers, but not
necessarily familiar with how to use the special
features of the HP 8360 series.
For the user wishing to program an HP 8360
Series Synthesized Sweeper. This section
contains an introduction to Standard Commands
for Programmable Instruments language
(SCPI), Hewlett-Packard’s implementation of
IEEE-488.2-1987, and an introduction to the
Analyzer programming language.
Note
If you are unpacking a new synthesizer, refer to the installation
suggestions provided in the “INSTALLATION” chapter of this
manual.
Getting Started Introduction
l-1
To Next Page
