HP 8360 - Softwarerev

SINGLE
Function Group
Menu Map
Description
Programming Codes
See Also
SWEEP
7
This hardkey selects single sweep mode, aborts any sweep in progress
and initiates a single sweep at a rate determined by the sweep time
function.
If you press (SINGLE) in the middle of a continuous sweep, the sweep is
aborted and the synthesizer retraces to the starting point but does
not start a sweep. Press
(=I a second time to start the sweep.
The amber LED above the hardkey is lit when the function is on.
SCPI:
1NITiate:CONTinuous OFF]0
ABORt
INITiate[:IMMediate]
Analyzer:
S2
(CONT)
“Continuous, Single and Manual Sweep Operation,” in Chapter 1.
“Programming Typical Measurements,” in Chapter 1.
Software Rev
Function Group
Menu Map
Description
Programming Codes
See Also
SYSTEM
8
This softkey displays the synthesizer’s programming language, HP-IB
address, and firmware date code.
SCPI: *IDN?
Analyzer: 01
HP-IB Menu, SCPI COMMAND SUMMARY
S-60 Operating and Programming Reference
HP 8360
User’s Handbook